SEARCH
This apparatus is in conformance with the valid European directives and standards regarding Radio and RoHS.
European representative of JVCKENWOOD Corporation is:
JVCKENWOOD Deutschland GmbH,
Konrad-Adenauer-Allee 1-11, 61118 Bad Vilbel, GERMANY
This apparatus is in conformance with the valid United Kingdom Regulations and standards regarding Radio and RoHS.
United Kingdom representative of JVCKENWOOD Corporation is:
JVCKENWOOD U.K. Limited, First Floor, Gleneagles, the Belfry, Colonial Way, Watford, Hertfordshire WD24 4WH, UNITED KINGDOM
Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste.
This product contains rechargeable battery. Contact JVCKENWOOD authorised dealer for disposal.
Hereby, JVCKENWOOD declares that the radio equipment [HA-FW1000T] is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: (https://www.jvc.net/euukdoc/).
Hereby, JVCKENWOOD declares that the radio equipment [HA-FW1000T] is in compliance with the relevant statutory requirements.
The full text of the declaration of conformity is available at the following internet address: (https://www.jvc.net/euukdoc/).
JVCKENWOOD Corporation
3-12,Moriya-cho,Kanagawa-ku,Yokohama-shi, Kanagawa, 221-0022, JAPAN
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Do not listen at high volume for an extended period. Do not use while driving or cycling.
Pay special attention to traffic around you when using the headphones outside. Failure to do so could result in an accident.
This product with a built-in battery shall not be exposed to excessive heat such as sunshine, fire or the like.
This product contains rechargeable battery, which is not replaceable. Danger of explosion if user replaced battery. Do not replace battery user own self.
Please do not handle the battery in the following manners.
It can lead to an explosion or leakage of flammable liquids and gases.
Dispose in fire, discard, crush or cut
Leave in extremely high temperature environment
Leave in extremely low pressure environment
To reduce the risk of electrical shocks, fire, etc.
Do not disassemble or modify the unit.
Do not allow flammable, water or metallic objects to enter the unit.
For your safety...
Stop using the headphones if they are causing great discomfort or irritation on the skin and the ears. They may damage your skin and cause rash or inflammation.
If ear pieces or other parts of headphones become lodged in your ear, be careful not to push it deep into the ear canal and seek skilled medical assistance to remove the piece. Damage to the ear may be caused by non-professionals attempting to remove the piece.
Store the ear pieces in a safe place where children cannot reach them to avoid the risk of a possible accident or hazard such as swallowing them.
In dryer air conditions such as in winter, you may feel some static shock when using the headphones.
Attach the ear pieces firmly when replacing them; failure to do so may result in the ear pieces getting lodged in your ear canal when removed, thus becoming a possible health hazard.
Precautions for use
Do not use the charging cable if the plug area is bent as this may cause fire, burns, or electric shocks. Do not allow the plug or the terminal of the unit to come into contact with liquids (such as sweat, beverages, and antiseptic spray) or foreign objects (such as small pieces of trash, dust, and metallic objects). Stop using immediately if the unit comes into contact with foreign objects or if there are abnormal noises, smells, or smoke emitting from the unit.
For replacement of the ear pieces, please consult your local dealer.
These headphones have a built-in magnet. Do not bring them near objects that may be affected by magnets such as watches, magnetic tape and magnetic cards.
If the headphones or the charging case is dirty, wipe the surface with a dry cloth.
If the charging terminals are dirty, clean the terminals with a cotton swab and the like.
As wood is used for this unit, it may differ in appearance for products and in the left and right earphones. The unit may also appear to have scratches because of the unique characteristics of wood.
About drip-proof...
Although these headphones units have drip-proof feature (IPX4), it is not completely water proof.
Not to be immersed or come into continuous contact with water.
Make sure that the headphone unit is free of dust and not wet before charging.
The charging case is neither drip-proof nor water-resistant. Pay careful attention to avoid contact with water or sweat as this may cause malfunction.
Supplier's Declaration of Conformity
Model Number : HA-FW1000T
Trade Name : JVC
Responsible party : JVCKENWOOD USA Corporation
Address: 1440 Corporate Drive, Irving, TX 75038
Telephone Number: 678-449-8879
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF energy.
ATTENTION:
The product you have purchased is powered by a rechargeable battery that is recyclable. Please call 1-800-8-BATTERY for information on how to recycle this battery.
CAN ICES-3 (B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. HA-FW1000T has been tested and found to comply with ISED radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules.
IC: 12522A-FW1000T
FCC ID: 2AKMBHA-FW1000T
Hearing Comfort and Well-Being
Do not play your personal audio at a high volume. Hearing experts advise against continuous extended play.
If you experience a ringing in your ears, reduce volume or discontinue use.
Traffic Safety
Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas.
You should use extreme caution or temporarily discontinue use in potentially hazardous situations.
Do not turn up the volume so high that you cannot hear sound around you.
To reduce the risk of electrical shocks, fire, etc.
Do not disassemble or modify the unit.
Do not allow flammable, water or metallic objects to enter the unit.
For your safety...
Stop using the headphones if they are causing great discomfort or irritation on the skin and the ears. They may damage your skin and cause rash or inflammation.
If ear pieces or other parts of headphones become lodged in your ear, be careful not to push it deep into the ear canal and seek skilled medical assistance to remove the piece. Damage to the ear may be caused by non-professionals attempting to remove the piece.
Store the ear pieces in a safe place where children cannot reach them to avoid the risk of a possible accident or hazard such as swallowing them.
In dryer air conditions such as in winter, you may feel some static shock when using the headphones.
Attach the ear pieces firmly when replacing them; failure to do so may result in the ear pieces getting lodged in your ear canal when removed, thus becoming a possible health hazard.
Precautions for use
Do not use the charging cable if the plug area is bent as this may cause fire, burns, or electric shocks. Do not allow the plug or the terminal of the unit to come into contact with liquids (such as sweat, beverages, and antiseptic spray) or foreign objects (such as small pieces of trash, dust, and metallic objects). Stop using immediately if the unit comes into contact with foreign objects or if there are abnormal noises, smells, or smoke emitting from the unit.
For replacement of the ear pieces, please consult your local dealer.
These headphones have a built-in magnet. Do not bring them near objects that may be affected by magnets such as watches, magnetic tape and magnetic cards.
If the headphones or the charging case is dirty, wipe the surface with a dry cloth.
If the charging terminals are dirty, clean the terminals with a cotton swab and the like.
As wood is used for this unit, it may differ in appearance for products and in the left and right earphones. The unit may also appear to have scratches because of the unique characteristics of wood.
About drip-proof...
Although these headphones units have drip-proof feature (IPX4), it is not completely water proof.
Not to be immersed or come into continuous contact with water.
Make sure that the headphone unit is free of dust and not wet before charging.
The charging case is neither drip-proof nor water-resistant. Pay careful attention to avoid contact with water or sweat as this may cause malfunction.
Please refer to the following for information on the European Guarantee.
Please refer to warranty information attached on your product.