Monitoring Audio Sound During Recording Using a Headphone

You can check the recorded audio using headphone.

360EC_AudioMonitor01
Connect the headphone.
Select the channel to monitor with the [MONITOR] selection switch.

Setting

Description

[CH1]

Outputs the audio recorded in [CH1].

[BOTH]

Outputs the audio recorded in [CH1/CH2].

[CH2]

Outputs the audio recorded in [CH2].

Use the [MONITOR +/-] button to adjust the monitor volume.
Memo

Audio during recording is not output from the monitor speaker.

Warning tone is output when there is an abnormality in the camera recorder or when the battery is low.

Selecting Audio Output Method When the [MONITOR] Selection Switch Is Set to “BOTH”

When a stereo type earphone jack is connected, perform the following setting to output stereo sound.

Set the [MONITOR] selection switch to “BOTH”.
Set [Main Menu] arrowR [A/V Set] arrowR [Audio Set] arrowR [Monitor] to “Stereo”.
Memo

You can set the volume of the warning tone in [Main Menu]  arrowR  [A/V Set]  arrowR  [Audio Set]  arrowR  [Alarm Level]. (“Off”/“Low”/“Middle”/“High”)