Use the operation buttons on the side control panel of the camera recorder to play back.
Set Button ( )
Plays back/pauses the clip pointed by the cursor.
You can press the cross-shaped button ( ) to perform frame-by-frame forward playback during pause mode.
Cross-shaped Button ( )
[ / ] Button:
Skips in the reverse or forward direction.
[ / ] Button:
During Playback:
Fast forwards in the reverse or forward direction.
While paused:
Frame-by-frame playback in the reverse or forward direction.
[CANCEL/STOP] Cancel/Stop Button
Stops playback.
Move the cursor to the clip to be played back using the cross-shaped button ( ).
Playback of the selected clip starts.
Audio Output during Playback
You can confirm the playback sound from the monitor speaker, or the headphone connected to the [ ] terminal. When a headphone is connected to the [ ] terminal, sound cannot be output from the monitor speaker.
Adjust the volume of the monitor speaker and headphone using the / volume buttons on the side of the camera recorder.
Time Code Playback
Time code or user’s bit recorded on an SD card can be displayed on the LCD monitor and viewfinder.
The time code is also superimposed on the video signal output from the [SDI OUT] terminal.
If a section without time code is played back, the time code will stop. However, playback will continue.
Displaying Information during Shooting
Pressing the [DISPLAY] button during playback displays the display screen.
Pressing the [OIS/6] button each time changes the shooting information displayed (camera information display and hide display).
Camera information display displays only information of Gain, Iris, Shutter and White Balance that have been recorded.
When [System] [Record Set] [Record Format] System is set to “HD+Web”, only SD or web files can be played back from slot B.
In this case, files up-converted into the HD size are played back in the simple mode.
Trimming information is displayed while trimming is in progress. In this case, pressing the [OIS/6] button does not switch the display.