By setting the number of seconds in the [Pre Rec Time], you can start recording video and audio before actual recording starts based on the [Pre Rec Time] setting.
When starting actual recording while the camera recorder is in Recording Standby (STBY ) mode, you can start recording a few seconds earlier based on the [Pre Rec Time] setting.
Using Pre Rec allows you to record a complete event without missing the initial scenes even if you start the recording late.
Pre Rec Time can be set in [Main Menu] [System] [Record Set] [Rec Mode] [Pre Rec Time].
The following values can be selected depending on the setting of [Main Menu] [System] [Record Set] [Record Format] [System].
When [System] is set to “4K”:
Fixed at “5sec”
When [System] is set to “HD” or “SD”:
“5sec”, “10sec” or “15sec”
Set [Main Menu] [System] [Record Set] [Rec Mode] to “Pre Rec”.
The display changes (“STBY” “STBY ”).
The display changes (“STBY ” “ REC ”) and the card slot status indicator lights up in red.
Press the [REC] button again to pause recording. The display changes (“ REC ” “STBY ”) and the card slot status indicator lights up in green.
When the interval between start and stop recording is short, “STBY ” may not be displayed immediately after recording is complete.
“ REC ” “STBY ” (“STBY” blinks in red) “STBY ” is displayed.
When the SD card becomes full during recording, recording stops and “STOP” is displayed.
In the following cases, video and audio before the specified Pre Rec time may not be recorded even if recording starts.
Immediately after power on
Immediately after recording stops
Immediately after switching from Media mode to Camera mode
Immediately after setting [Rec Mode]
Immediately after the end of Clip Review
Immediately after changing file format
Immediately after changing video format