Display Type Item

This menu is used to set the displays on the LCD monitor and viewfinder screen.

Battery

For setting the display of the remaining battery power on the LCD monitor and viewfinder screen.

Time:
Displays the remaining battery power in minutes. (min)

Capacity%:
Displays the remaining battery power in percentage. (%)

Voltage:
Displays the current battery voltage in units of 0.1 V. (V)

[Setting Values: REC button Time, Capacity%, Voltage]

Memo

The battery mark that appears before the “Time”, “Capacity%” or “Voltage” value changes according to the remaining battery power.

BATT_4 :

Battery which the capacity could not be acquired

BATT_0B :

Below 13%

BATT_1 :

13% or higher

BATT_2 :

30% or higher

BATT_3 :

60% or higher

BATT_unknown :

Battery communication error

BATT_CAL :

Calibration required

While “Time” or “Capacity%” is displayed, “ BATT_0 ” appears when the level falls below the setting in [System] arrowR [Battery] arrowR [Near End (%)]. Replace the battery as soon as possible.

The remaining battery power and remaining time are intended as reference values for the shooting duration.

When the battery that is connected does not support communication, the voltage is displayed regardless of the setting.

Zoom

For setting the display method of the zoom position.

Number:
Displays the zoom position in numbers (Z00 to 99).

Bar:
Displays the zoom position in a bar.

[Setting Values: Number, REC button Bar]

Memo

This item will not be displayed if the lens attached does not support zoom position information.

Focus

For setting the display method of the approximate distance to the subject in focus during manual focus.

Feet:
Displays the distance in feet.

Meter:
Displays the distance in meters.

[Setting Values: Feet, REC button Meter]

Memo

This item will not be displayed if the lens attached does not support focus position information.

Shutter

For setting the shutter display to be displayed on the LCD monitor and viewfinder screen.

DEG:
Displays the shutter speed in degrees in the same way as film cameras.

SEC:
Displays the shutter speed in seconds.

[Setting Values: DEG, REC button SEC]

Memo

“DEG” is selectable only when [ SlotA_B Frame Rate] is set to “24p” or “25p”.
When [ SlotA_B Frame Rate] is set to other values, the shutter display setting is fixed at “SEC” and cannot be selected.

SlotA_B Frame Rate/ EXT Frame Rate

When a remote control unit is connected to the [REMOTE] terminal, “SEC” is displayed and selection is disabled.

Gain

For setting the gain display to be displayed on the LCD monitor and viewfinder screen.

ISO:
Displays the gain as ISO sensitivity.

dB:
Displays the gain in dB (decibel).

[Setting Values: ISO, REC button dB]

Memo

This item cannot be configured when [Color Space] is set to “HLG”.

Audio Meter

For specifying whether to display the audio level meter on the LCD monitor and viewfinder screen.

Auto:
4ch display when [System] arrowR [Record Set] arrowR [Record Format] arrowR [ SlotA_B Audio] is set to “4CH”, and 2ch display ([CH1]/[CH2]) in all other cases. Whether 4 channels or 2 channels ([CH1]/[CH2]) are displayed during playback is dependent on the recorded clip.

CH1/2:
Displays the audio level meter for [CH1] and [CH2].

[Setting Values: REC button Auto, CH1/2]