Error Messages and Actions

Warning display on the LCD monitor and viewfinder screen, tally lamp indication and warning tone are as follows according to the error status.

Memo

This camera recorder makes use of a microcomputer. Noise interference from external sources may prevent it from functioning properly. When this occurs, turn off and on the power of the camera recorder again.

Error Message	Status	Action
Turn Power Off Turn Back On Later	System error. The warning tone sounds and the tally lamp blinks twice every second.	Turn off the power, and turn it on again. If the error persists, please contact the local dealers in your area.
Fan Stop Detected Please Turn P.Off	The fan stopped running.	Please contact the local dealers in your area.
Fan Maintenance Required	Usage time of the fan has exceeded 9000 hours.	Check the fan and replace accordingly. For more details, please contact the local dealers in your area. Memo You can check the usage time of the fan in [System] [System Information] [Fan Hour]. Fan Hour
Getting Overheated. Please Turn Power Off.	The battery has exceeded the specified temperature. The power turns off automatically after about 15 second.	Wait until the temperature drops or replace the battery. If the error persists, please contact the local dealers in your area.
Rec Inhibited	[REC] button is pressed when the write-protect switch of the SD card is set.	Turn off the write-protect switch of the SD card, or insert a recordable SD card. Recording Media
Lost Media Info *	Card is removed while recording is in progress. Card is removed while formatting is in progress. Card is removed while restoring is in progress. Card is removed while adding the OK mark. Card is removed while writing a setup file. Card is removed while deleting a clip. (*: A, B)	Restore the card using this camera recorder. Repairing the Recording Media
Record Format Incorrect	The video format of the file for Clip Review is different from the current [ Resolution], [ Frame Rate], or [ Bit Rate] setting.	Set [ Resolution], [ Frame Rate] and [ Bit Rate] correctly. Resolution/ Resolution Frame Rate/ Frame Rate Bit Rate/ Bit Rate
Media Full	[REC] button is pressed when the media in use has no remaining space. Remaining space ran out during recording.	Replace the recording media with a new one.
No Clips	No viewable clips are found on the card for Clip Review.	Insert an SD card that contains clips that can be reviewed. Recording Media Viewing Recorded Videos Immediately (Clip Review)
No Media	When the [REC] button is pressed while a recording media is not inserted.	Insert a recording media. Recording Media
No Media	No recording media is inserted while in Media mode or when the thumbnail screen is displayed.	Insert a recording media. Recording Media
No Clips	No clips are found in the inserted recording media while in Media mode or when the thumbnail screen is displayed.	Insert a recording media that contains playable clips. Recording Media Playing Recorded Clips
Please review the connected devices due to over current.	Peripheral devices are connected in an environment that is subject to high temperature, and overcurrent has occurred as a result. Memo The backlight of the LCD monitor may automatically be adjusted to “Dark” as a form of overcurrent protection.	Take the necessary actions such as removing the USB devices that are connected to the camera. The power of the camera may shut down if you continue using it in this state.