Connecting to Network via Built-in Wireless LAN 900CHU 900CHE

Configure the connection settings with [Wizard].

Select “USB/Int. WLAN” in [Network] arrowR [Connection Setup] arrowR [Wizard], and configure the settings according to the instructions on the screen.

Perform setting for the following.

Mode of connection

Configuration method

For P2P connections, it is necessary to configure the [Default Gateway] and [Passphrase] according to the steps below after the above settings are configured.

Set [Network] arrowR [Connection Setup] arrowR [Default Gateway] to “USB/Int. WLAN”.
Set the camera recorder to the Camera mode, and display the [USB/Int. WLAN] (status) screen.

Press the [STATUS/SET] button on the camera recorder to display the status screen. Press the cross-shaped button ( L_botton R_botton ) to display the [USB/Int. WLAN] screen.

Check to ensure that the [SSID] and [Passphrase] that you have set in the wizard are displayed.

Select an SSID from the list of access points (smartphone, tablet terminal, PC, etc.) and enter a passphrase.

Display the list of access points in the wireless connection settings of the smartphone, tablet terminal, or PC, and select “HC900-****”. (**** are numbers that vary with the device used.)

After the password confirmation screen appears, enter the [Passphrase] displayed on the [USB/Int. WLAN] screen.

Setting is complete.

After setting is complete, you can access the camera recorder via a web browser.

Memo

After setting is complete, the following items will be automatically configured.

The [Network] arrowR [Connection Setup] arrowR [USB/Int. WLAN] setting changes to “On”.

The [Network] arrowR [Connection Setup] arrowR [Default Gateway] setting changes to “USB/Int. WLAN”. However, this does not apply to the P2P connection.

The [Network] arrowR [Live Streaming] arrowR [Interface] setting changes to “USB/Int. WLAN”.