Function
TOPTrigger
For setting whether to supply a 12 V output to devices such as an external screen equipped with a trigger function.
|
Setting |
Description |
|---|---|
|
Off |
No output. |
|
On (Power) |
Outputs control signals (12 V) from the trigger terminal when the power is turned on. When the power is turned off, the control signal output is stopped when the cooling function starts. |
|
On (Anamo) |
Outputs control signals when the “Anamorphic” setting is switched from “Off” to “A” or “B”. |
Off Timer
For setting the duration before the power turns off automatically when the projector is not operated.
Setting values: “Off”, “1 Hour”, “2 Hours”, “3 Hours” and “4 Hours”
ECO Mode
|
Setting |
Description |
|---|---|
|
On |
Enables “ECO Mode” to minimize power consumption in the Standby mode. RS-232C / LAN communication cannot be used in the Standby mode. If there is no signal transmission and operation for 20 minutes while an image is projected, the power management switches the equipment automatically into standby mode. |
|
Off |
Select this option to control via RS-232C / LAN communication in the Standby mode or if Control4 is to be used. |
Network
Specify the settings below during external control such as from a PC or smartphone.
|
Setting |
Setting |
Description |
|---|---|---|
|
DHCP Client |
On |
Obtains the IP address automatically from the DHCP server inside the connected network. |
|
Off |
For configuring the network settings manually. |
|
|
IP Address |
For configuring the IP address. |
|
|
Subnet Mask |
For configuring the subnet mask. |
|
|
Default Gateway |
For configuring the default gateway. |
|
|
MAC Address |
Displays the MAC address of the unit. |
|
|
Set |
Applies the network settings. |
|
|
Control4 |
Set to “On” to allow Control4 SDDP to detect this unit. |
|
DHCP:
Abbreviation for Dynamic Host Configuration Protocol. This is a protocol for the network to assign an IP address automatically to the connected device.
IP Address:
Numeric characters for identifying the device that is connected to the network.
Subnet Mask:
Numeric characters that define the bit count used for the network address that is a segment of the IP address.
Default Gateway:
Server for communicating beyond the network that is divided by the subnet mask.
MAC Address:
Abbreviation for Media Access Control address. This is a number that is unique to each network adapter. Each of the network adapters is assigned with a unique MAC address.
Remote Code
For changing the remote control code.
You need to configure the remote control according to the settings of this unit.
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to switch the code.
The backlight of the remote control blinks 3 times: change the remote control code to “A”
The backlight of the remote control blinks 2 times: change the remote control code to “B”
|
Setting |
Description |
|---|---|
|
A |
Change the remote control code from “B” to “A”. |
|
B |
Change the remote control code from “A” to “B”. |
Lamp Reset
For resetting the lamp time to “0”.