Frame Rec

In normal recording, when the recording stops, the image and accompanying data from the start till the end of the recording are recorded as one “clip” on the SD card.

In this mode, recording starts with every press of the [REC] button, and only the specified number of frames is recorded.

The recording can be written to the media as a single clip until it is stopped.

Memo

Audio will not be recorded.

Until a specified amount of recordings is accumulated, the file cannot be written to the media.

If the specified amount is not reached when recording is stopped, normal recording is performed and frames are added to the ending of the clip until the amount is reached. (Padding)

After the specified number of frames is recorded and written to the media, recording will be performed until the same number is accumulated again.

FrameRec_02
Set [Rec Mode] to “Frame Rec”.

Set [Main Menu] arrowR [System] arrowR [Record Set] arrowR [Rec Mode] to “Frame Rec”.

The display changes (“STBY” arrowR “STBY BALP_F ”).

Set the number of frames to record in [Rec Frames].

Set using [Main Menu] arrowR [System] arrowR [Record Set] arrowR [Rec Mode] arrowR [Rec Frames].

Start recording.

Press the [REC] button to record only the number of frames specified in [Rec Frames] and pause.

The display changes (“STBY BALP_FarrowRREC button REC BALP_FarrowR “STBY BALP_F ” (yellow text)).

The card slot status indicator lights up in green.

Repeat Frame Rec.

Press the [REC] button again to record only the number of frames specified in [Rec Frames] and pause.

The display changes (“STBY BALP_FarrowRREC button REC BALP_FarrowR “STBY BALP_F ” (yellow text)).

Frame Rec continues until the recording is stopped (step Step5 ).

Press and hold the [REC] button.

The card slot status indicator lights up in green.

Caution

Do not remove the SD card during recording (“ REC button REC BALP_F ”, red text) or recording pause (“STBY BALP_F ”, yellow text).

To remove the SD card during Frame Rec, press the [CANCEL] button, check that “STBY BALP_F ” (white text) is displayed and the card slot status indicator lights up in green before you remove the card.

When [Main Menu]  arrowR  [TC/UB]  arrowR  [TC Generator] is set to “Free Run” or “Free Run(Ext)”, the time code will be recorded in “Rec Run”.

Audio cannot be recorded. A Prohibit mark appears in the audio level meter display.