Example:
In normal recording, three clips are generated as Recording 1, Recording 2, and Recording 3. However, recording in this mode generates only one clip.
Clip Continuous Rec
In normal recording, when the recording stops, the image, audio, and accompanying data from the start till the end of the recording are recorded as one “clip” on the SD card.
This mode allows you to consolidate several rounds of “startstop recording” into one clip.
Set “Rec Mode” to “Clip Continuous”.
Set [Main Menu] 
[System] [Record Set] [Rec Mode] to “Clip Continuous”.
The display changes (“STBY” “STBY 
”).
Start recording. (Recording 1)
Press the [REC] button to start recording in Clip Continuous mode.
The display changes (“STBY ” “ 
REC ”) and the card slot status indicator lights up in red.
Pause recording.
Press the [REC] button again to pause recording. The display changes (“ REC ” “STBY ” (yellow text)).
The card slot status indicator remains lighted in red.
Memo
When the [CANCEL] button is pressed while the camera recorder is paused (STBY ), the display changes (“STBY ” (yellow text) “STBY ” (blinking yellow text) “STBY ” (white text)), and a “clip” is generated. The card slot status indicator lights up in green.
Resume recording. (Recording 2)
Press the [REC] button again to resume recording. The display changes (“STBY ” (yellow text) “ REC ”).
The card slot status indicator remains lighted in red.
Pause recording.
Press the [REC] button again to pause recording. The display changes (“ REC ” “STBY ” (yellow text)).
The card slot status indicator remains lighted in red.
Resume recording. (Recording 3)
Press the [REC] button again to resume recording. The display changes (“STBY ” (yellow text) “ REC ”).
The card slot status indicator remains lighted in red.
Press and hold the [REC] button.
Recording stops and the display changes (“ REC ” “STBY ”). A “clip” is generated.
The card slot status indicator lights up in green.
Press the [REC] button again.
The display changes (“STBY ” “ REC ”) and the card slot status indicator lights up in red.
A new “clip” is generated from here.
Memo
The following operations cannot be performed while recording is paused (STBY , yellow text).
Clip Review operation
Switching SD card slots
Switching operation mode
Caution
Do not remove the SD card during recording ( REC , red text) or recording pause (STBY , yellow text).
To remove the SD card in the “Clip Continuous” mode, press the [CANCEL] button, check that “STBY ” (white text) is displayed and the card slot status indicator lights up in green before you remove the card.
When the SD card becomes full during recording, recording stops and “STOP” is displayed.
When the [POWER ON/OFF] switch is turned off during recording or recording pause, recording stops and power is cut off after a clip is generated.
Caution
If the power is cut off due to low battery power, a proper clip may not be generated.
