You can check (review) the last recorded video clip on the screen.
Viewing Recorded Videos Immediately (Clip Review)
However, the video clip cannot be played back if the settings of the camera recorder are different from the video format (Resolution/Frame & Bit Rate/SD Aspect) of the clip.
Memo
To use this function, assign “Clip Review” to any of the user buttons. “Clip Review” is assigned to
“Clip Review” can also be assigned to other user buttons.
Press the button assigned with the “Clip Review” function during standby (“STBY” is displayed).
Playback of the configured section starts.
Memo
The video clip is played back according to the setting in [Main Menu] 
[Camera Function] [User Switch Set] [Clip Review]. By default setting (Last 5sec), the last 5 seconds of the clip is played back.
When playback is complete, the camera recorder exits Clip Review and returns to “STBY” (recording standby) mode.
Caution
During Clip Review, only the [CANCEL] and [REC] buttons are enabled.
Press the [CANCEL] button to cancel clip review and return to “STBY” (recording standby) mode.
Press the [REC] button to cancel clip review and enter recording mode. It will take some time to start recording after the button is pressed.
When the last clip is less than 5 seconds, the whole clip is played back.
Only video clips in the currently selected slot can be reviewed.
When there are no clips in the selected slot, Clip Review function is disabled.
Clip Review is unavailable when Clip Continuous Rec is paused (“STBY 
”, yellow text). To operate Clip Review, use the [CANCEL] button to set to “STBY ” (white text) first.
Clip Review is unavailable when the camera recorder is connected to an external equipment and the equipment is in recording state.
Clip Review does not function while the record trigger is in the REC state.
