Use the supplied AC adapter to operate the camera recorder with AC power.
Using AC Power (DC IN Power)
Connect the DC cable of the AC adapter to the [DC] terminal of the camera recorder.
Check that the power switch of the camera recorder is set to “OFF”.
Open the cover of the [DC] terminal and connect as shown in the diagram.
Hold down the lock button (blue) at the center of the [POWER ON/OFF] switch to set to “ON”.
Power will be supplied to the camera recorder.
Caution
Do not insert or remove the DC cable during recording.
Do not use power supply of high voltage fluctuation, containing noise such as ripple, or with insufficient capacity.
Charging the Built-In Battery
The date/time and time code data are stored using the built-in rechargeable battery.
When power is connected to the camera recorder, the built-in battery always gets charged. When the power is disconnected, the battery gradually discharges.
The battery will be totally discharged if left unused for 3 months and the date/time and time code data will be reset. When this happens, set the [POWER ON/OFF] switch to “ON” to display the [Initial Setting] screen, then set the date/time.
