Changing the Settings

PASSWORD Sets the password to access the camera.

ENFORCED GROUP OWNER (Default: “ON”) Set whether or not to get the owner group permissions. ・ OFF: Set this if connection to devices that support Wi-Fi Direct fails. (When set to OFF, connection to devices that do not support Wi-Fi Direct will be disabled.) ・ ON: It is recommended to set this usually.

HTTP PORT (Default: “80”) Changes the port number to access to the camera.

PASSWORD (Default: “0000”)
Selects the password to access the camera.

HTTP PORT (Default: “80”) Changes the port number to access to the camera.

PASSWORD (Default: “0000”)
Selects the password to access the camera.

UPnP (Default: “ON”)
Sets the UPnP of the camera.
・ OFF: Disables UPnP.
・ ON: Enables UPnP.

DDNS SETTING
Configures various settings related to DDNS.

HTTP PORT (Default: “80”) Changes the port number to access to the camera.

DETECT/ MAIL ATTN. Selects the recipient’s e-mail address for Detect/Mail.

MAIL SETTING
Sets the e-mail addresses of the sender and recipient.

DETECTION METHOD (Default: “MOTION DETECTION”) Sets the detection method to start recording. ・ MOTION DETECTION: Starts recording upon detection of subject’s movements. ・ FACE DETECTION: Starts recording upon detection of human faces.

DETECTION INTERVAL (Default: “10 minutes”)
Sets the time period to enable detection again after the previous one.

SELF RECORDING (Default: “ON”)
Sets whether to record videos on this camera during detection.
・ OFF: Does not record videos on this camera.
・ ON: Records videos on this camera.

VIDEO MAIL ADDRESS Selects the recipient’s e-mail address for video mails.

MAIL SETTING
Sets the e-mail addresses of the sender and recipient.

MAC ADDRESS FILTER (Default: “OFF”) By setting to “ON”, Everio can be searched from the device (TV monitor); the MAC address of the device needs to be registered to Everio in advance. ・ OFF: Disables UPnP. ・ ON: Enables UPnP.

MAC ADDRESS LIST MAC address of the TV monitor can be registered to the camera.

ACCESS POINTS
Adds, deletes, or perform LAN settings of access points (wireless LAN router).

MAIL SETTING
Sets the e-mail addresses of the sender and recipient.

MAC ADDRESS (Media Access Control address) Displays the MAC address of the camera. (The above shows the MAC address when connected to an access point, while the below shows the address during direct connection.)

SET FROM QR CODE Perform the Wi-Fi setting after the camera reads the QR code generated by following the instruction in Detailed User Guide.

LOCK SETTINGS
Sets a password to prevent others from seeing the network settings.

INITIALIZATION
Returns the network settings to their default values.