> Connecting (Power On) > Reconnect

Reconnect

Turn on the Bluetooth function on the device to connect, followed by taking both earphones from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

Be careful not to touch the touch sensor area when taking them out.

Case_button_A50T + Case_button_A50T

Touch sensor area

If reconnection cannot be established, operate the BLUETOOTH device to connect.

1Check that the power of the earphones is off. Power Off

2Turn on the BLUETOOTH function of the device to connect, followed by touching and holding the L and R touch sensor area of the earphones at the same time for about 3 seconds.

PLAY_button_LR_A50T + Button LR A50T

Touch sensor area

[L]

  1. The indicator flashes and the power turns on.

  2. When the indicator starts to flash slowly, the earphones will attempt to establish connection with the last connected device.

  3. After connection is established, the L indicator continues to flash every 5 seconds.

    4. blue_flash_A50T_L

[R]

  1. The indicator flashes and the power turns on.

  2. It will attempt to connect with the L earphone.

  3. After connection is established, the R indicator starts to flash every 5 seconds.

    4. blue_flash_A50T

    The earphones reconnect with the device that was last connected and can now be used for listening to music.

If reconnection cannot be established, operate the BLUETOOTH device to connect.

If the R indicator only flashes twice or flashes rapidly, this means the L and R earphones are not connected to each other. In this case, turn off the power of both the L and R earphones, followed by turning on their power again at the same time.

Touching and holding the touch sensor area for about 5 seconds switches the indicators to flash quickly. If this occurs, turn off the power of the earphone and repeat the steps from the beginning. Power Off

Pressing and holding the touch sensor area for about 10 seconds while the earphones are in the charging case initializes the pairing (device registration) information. In this case, perform pairing (device registration) again.
Pressing and holding the touch sensor area for about 20 seconds while the earphones are in the charging case initializes the pairing (device registration) information and deletes the connection information for the L and R earphones. When this occurs, reset the earphones to the factory default state. Restoring the settings to the initial state