> Connecting (Power On) > Using only one earphone

Using only one earphone

After the BLUETOOTH function of the device to connect is turned on, one earphone can now be used on its own.

The L earphone is used in the illustration below.

Take out the earphone that you wish to use from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

Press the earphones with your thumbs to take them out of the case.

take_out_L_NP35T

Be careful not to touch the touch sensor area when taking them out.

Case_button_L_NP35T_U + Case_button_L_NP35T_U

Touch sensor area

For remote control operation, only the earphone that is in use can be used.

To use the earphone that is not inside the charging case, touch the touch sensor area of the earphone for about 3 seconds to turn on the power.

If pairing has not been performed, do so before using. Pairing (Registering a device)

To use both earphones, put the earphones back into the charging case, wait till their power goes off and remove them from the case.