Adjusts the angle of view.
Optical zoom ratio: 1x to 12x
Dynamic zoom ratio: 12x to 24x
Set the dynamic zoom “On”/“Off” in [Main Menu] [Camera Function] [Dynamic Zoom].
Zooming can be operated using any of the three levers/rings below.
Zoom Lever at the Grip
Zoom lever at the Handle
Zoom Ring at the Lens Section
During the zoom operation, the zoom bar or number will appear on the upper right corner of the screen.
Using the Zoom Lever at the Grip
The zoom speed changes according to the extent the zoom lever is being pushed.
Zooms into wide angle and increases the angle of view when “W” is pressed.
Zooms into telephoto and decreases the angle of view when “T” is pressed.
Using the Zoom Lever at the Handle
Set the zoom speed for “L”, “M” and “H” of the [ZOOM L/M/H] zoom speed switch individually.
Increasing the value increases the zoom speed.
The zoom lever at the handle is disabled when “Off” is selected.
The zoom operation is performed in the speed that has been set.
Using Zoom Ring at the Lens Section
You can adjust the preferred angle of view by turning the zoom ring.
Saving/Recalling Current Zoom Position (Preset Zoom)
This allows you to register up to three zoom positions.
Press any of the user buttons assigned with the “Preset Zoom1”, “Preset Zoom2”, or “Preset Zoom3” function for more than 1 second.
The current zoom position will be stored.
Press any of the user buttons assigned with the “Preset Zoom1”, “Preset Zoom2”, or “Preset Zoom3” function and release within 1 second.
The camera recorder zooms to the stored zoom position.
The zoom speed to the zoom position can be set in [Main Menu] [Camera Function] [User Switch Set] [Preset Zoom Speed].
Operating other zoom maneuvers during a zoom position recall will cancel the recall.