To use this camera recorder, you can attach a battery pack or connect an AC adapter to it.
Power Supply
Caution
Set the [POWER ON/OFF] switch to “OFF” before changing the power supply that operates this camera recorder.
Use the camera recorder and peripheral equipments within the rated output of the AC adapter.
To connect other peripheral equipment, do so under the following conditions.
Keep the total power consumption of the peripheral equipments under 35 W when using the recommended battery.
Keep the total power consumption of the peripheral equipments under 65 W when using Tandem 150 (recommended AC adapter). 
Keep the total power consumption of the peripheral equipments under 50 W when using AC-100 (recommended AC adapter). 
The power consumption of the [LIGHT] terminal is below 50 W. Keep the total power consumption of the peripheral equipments excluding the [LIGHT] terminal under 35 W when using the terminal. If the total power consumption of the peripheral equipments exceeds the rating, the power to the [LIGHT], [DC OUT] (rear) and [DC OUT] (LAN) terminals is automatically cut off. This is not a malfunction. Use peripheral equipments with lower power consumption then turn on the power of this camera recorder again.
To check the power consumption, refer to the Power screen of the Status screen.
If the voltage of the [DC INPUT] becomes 12 V or less, the USB adapter connected to the [HOST] terminal cannot be used. Check the power supply and the peripheral equipments, and turn on the power of this camera recorder again.
Use a power supply of 12 V/ 2A or below for the [LIGHT] terminal.
The [LIGHT] terminal, DC OUT terminal (rear)/DC OUT (LAN) terminal and the D-tap terminal of the battery loading folder cannot be used at the same time. 
