Adjusts the angle of view.
Zoom Operation
Optical zoom ratio: 1x to 20x
Dynamic zoom ratio: 1x to 40x
Set using [Camera Function] 
[Zoom] [Dynamic Zoom].
Zooming can be operated using the following.
Zoom Lever at the Grip
Zoom Lever on Handle
Zoom Ring at the Lens Section
During the zoom operation, the zoom bar or number will appear on the upper right corner of the screen.
Caution
Depending on the zoom speed, the zoom drive noise of the power zoom may be recorded.
Using the Zoom Lever at the Grip
Press the zoom lever to zoom.
The zoom speed changes according to the extent the zoom lever is being pushed.
Zooms into wide angle and increases the angle of view when “W” is pressed.
Zooms into telephoto and decreases the angle of view when “T” is pressed.
Using the Zoom Lever at the Handle
Set the [FIX/VAR/OFF] zoom speed switch to “FIX” or “VAR”.
Memo
Setting to “FIX” will allow the zoom operation to move at the speed set in [Handle Zoom Speed].
Set the zoom speed using [Camera Function] [Zoom] [Handle Zoom Speed].
Press the zoom lever at the handle to zoom.
Memo
When the [FIX/VAR/OFF] zoom speed switch is set to “OFF”, the zoom lever at the handle section cannot be used.
Using Zoom Ring at the Lens Section
You can adjust the preferred angle of view by turning the zoom ring.
Saving/Recalling Current Zoom Position (Preset Zoom)
This allows you to register up to three zoom positions.
Assign the “Preset Zoom1”, “Preset Zoom2”, or “Preset Zoom3” function to any of the user buttons.
Save the current zoom position.
Press any of the user buttons assigned with the “Preset Zoom1”, “Preset Zoom2”, or “Preset Zoom3” function for more than 1 second.
The current zoom position will be stored.
Recall the stored zoom position.
Press any of the user buttons assigned with the “Preset Zoom1”, “Preset Zoom2”, or “Preset Zoom3” function and release within 1 second.
The camera recorder zooms to the stored zoom position.
Memo
Set the speed for shifting to the preset zoom position and the rate of change for starting and stopping the preset zoom operation in [Camera Function] [Zoom] [Preset Zoom] [Speed]/[Ease In]/[Ease Out].
Operating other zoom maneuvers during a zoom position recall will cancel the recall.
