> Connecting (Power On) > Reconnect

Reconnect

Turn on the Bluetooth function on the device to connect, followed by taking both earphones from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

connecting_A10T_1

If reconnection cannot be established, operate the BLUETOOTH device to connect.

1Check that the power of the earphones is off. Power Off

2Turn on the BLUETOOTH function of the device to connect, followed by pressing and holding the button on the L and R earphones at the same time for about 3 seconds.

PLAY_button_LR_A10T

[L]

  1. The indicator on the earphone lights up in white for 1 second and the power turns on.

  2. When the indicator starts to flash slowly in red, the earphones will attempt to establish connection with the last connected device.

  3. After connection is established, the L indicator starts to flash slowly in white.

    4. blue_flash_A10T_L

[R]

  1. The indicator on the earphone lights up in white for 1 second and the power turns on.

  2. When the indicator starts to flash slowly in red, it will attempt to establish a connection.

  3. After connection is established, the R indicator flashes twice in white and switches to a slow flash.

    4. blue_flash_A10T

    The earphones reconnect with the device that was last connected and can now be used for listening to music.

If reconnection cannot be established, operate the BLUETOOTH device to connect.

If the R indicator is flashing in red, this means the L and R earphones are not connected to each other. In this case, turn off the power of both the L and R earphones, followed by turning on their power again at the same time.

Pressing and holding the button of the L earphone for about 5 seconds switches the L indicator light to a quick flash that alternates between red and white. If this occurs, turn off the power of the earphone and repeat the steps from the beginning. Power Off

Pressing and holding the button on the L earphone for about 10 seconds initializes the pairing (device registration) information. In this case, perform pairing (device registration) again.
Pressing and holding the button on the L earphone for about 20 seconds initializes the pairing (device registration) information as well as the connection information of the L and R earphones. In this case, perform pairing (device registration) again after the L and R earphones are initialized. Restoring the settings to the initial state

Pressing and holding the button on the R earphone for about 20 seconds initializes the settings of the earphones. In this case, perform pairing (device registration) again after the L and R earphones are initialized. Restoring the settings to the initial state