> Connecting (Power On) > Reconnect

Reconnect

Turn on the Bluetooth function on the device to connect, followed by taking both earphones from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

Be careful not to touch the touch sensor area when taking them out.

Case_button_LR_A4T + Case_button_LR_A4T

Touch sensor area

If reconnection cannot be established, operate the BLUETOOTH device to connect.

If connection (pairing) is not completed within 5 minutes after the indicator starts flashing, the earphone automatically turns itself off.

1Check that the power of the earphones is off. Power Off

2Turn on the Bluetooth function of the device to connect, followed by tapping and holding the touch sensor on both the L and R earphones at the same time for about 3 seconds.

PLAY_button_LR_A4T + Button_LR_A4T

Touch sensor area

  1. The indicator lights up for 1 second and the power turns on.

  2. The indicator flashes twice slowly and the unit automatically tries to establish connection with the last connected device.

  3. After connection is established, the L and R indicators continue to flash every 5 seconds.

  4. blue_flash_A4T

    The earphones reconnect with the device that was last connected and can now be used for listening to music.

If reconnection cannot be established, operate the BLUETOOTH device to connect.

If you cannot hear sounds from both earphones, it means that the L and R earphones are not connected. In this case, turn off the power of both the L and R earphones, followed by turning on their power again at the same time.

If connection (pairing) is not completed within 5 minutes after the indicator starts flashing, the earphone automatically turns itself off.