> Connecting (Power On) > Reconnect

Reconnect

Connecting to a device with the earphones taken out from the charging case

Turn on the Bluetooth function on the device to connect, followed by taking both earphones from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

connecting 1 XC70

Connecting to a device when the earphones are not inside the charging case

1Check that the power of the earphones is off. Power Off

2Turn on the Bluetooth function of the device to connect, followed by pressing the Multi Button TWS button on both the L and R earphones at the same time for about 3 seconds.

PLAY button XC70

[L]

  1. The indicator on the earphone lights up in blue for 1 second and the power turns on.

  2. When the indicator starts to flash slowly in red, the earphones will attempt to establish connection with the last connected device.

  3. After connection is established, the L indicator starts to flash slowly in blue.

    4. blue_flash XC70BT_L

[R]

  1. The indicator on the earphone lights up in blue for 1 second and the power turns on.

  2. When the indicator starts to flash slowly in red, it will attempt to establish a connection.

  3. After connection is established, the R indicator flashes twice in blue and switches to a slow flash.

    4. blue_flash XC70BT

    The earphones reconnect with the device that was last connected and can now be used for listening to music.

If the R indicator is flashing in red, this means the L and R earphones are not connected to each other. In this case, turn off the power of both the L and R earphones, followed by turning on their power again at the same time.

Pressing and holding the Multi Button TWS button of the L earphone for about 5 seconds switches the L indicator light to a quick flash that alternates between red and blue. If this occurs, turn off the power of the earphone and repeat the steps from the beginning. Power Off

Pressing and holding down the Multi Button TWS button on the R earphone for about 15 seconds initializes the settings of the earphones. In this case, perform the steps in Pairing (Registering a Device) again after the L and R earphones are initialized. Restoring the settings to the initial state