Adjusts the angle of view.
Zoom Operation
Zooming can be operated using the following.
Zoom ring/zoom lever on the commercially available lens
User buttons assigned with “Zoom Tele” and “Zoom Wide”
During the zoom operation, the zoom bar or number will appear on the upper right corner of the screen.
Caution
Depending on the zoom speed, the zoom drive noise of the power zoom may be recorded.
Using Zoom Ring/Zoom Lever on Commercially Available Lens
You can adjust the preferred angle of view by turning the zoom ring or operating the zoom lever.
Memo
For details on the lens, please refer to the “INSTRUCTIONS” of the lens used.
Using User Buttons Assigned with “Zoom Tele” and “Zoom Wide”
Assign “Zoom Tele” and “Zoom Wide” to the user buttons.
Configure the zoom speed of the user buttons in [Camera Function] 
[User Switch Set] [Zoom Speed].
Increasing the value increases the zoom speed.
Press the user button assigned with “Zoom Tele”/“Zoom Wide” to zoom.
The zoom operation is performed in the speed that has been set.
Memo
This function may not work depending on the lens attached.
