Connect a PC to this camera recorder directly using a cross-over cable or via devices such as an Ethernet hub using a LAN cable.
Camera Setup for Network Connection
Connect using the corresponding method of connection
[LAN] Terminal
Built-in Wireless LAN 
Attach the wireless LAN antenna if it is not mounted.
Connect the following adapters to the [HOST] terminal (USB)
Wireless LAN adapter
Ethernet adapter
Cellular adapter
Memo
Only a network connection adapter can be connected to the [HOST] terminal (USB).
Connect or disconnect an adapter only after you have turned off the power of the camera recorder.
You can find the latest information on the compatible adapters at the product page of our website.
Two types of network coverage (WAN and LAN) are available for each application.
Caution
When [System] 
[Record Set] [Record Format] [System] is configured to “High-Speed”, network cannot be used via wireless LAN or the [HOST] terminal (USB). Configure as follows in this case.
Set [Network] [Connection Setup] [USB/Int. WLAN] to “Off”.
Unplug the USB network adapter
Note that camera operation will come to an emergency stop and the power will turn off if the above steps are not performed.
File data may be damaged if this happens while recording is in progress.
