> Connecting (Power On) > Using only one earphone

Using only one earphone

After the BLUETOOTH function of the device to connect is turned on, one earphone can now be used on its own.

The L earphone is used in the illustration.

Take out the earphone that you wish to use from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

Be careful not to touch the touch sensor area when taking them out.

Case_button_L_A30T2 + Case_button_L_A30T2

Touch sensor area

Touch sensor operation is only applicable to one side of the earphone that is in use.

When using only one earphone, switching of the noise canceling function, the ambient sound function (Touch & Talk function) and the low latency mode cannot be used.

To use the earphone that is not inside the charging case, touch the touch sensor area of the earphone for about 3 seconds to turn on the power.

If pairing has not been performed, do so before using. Pairing (Registering a device)

To use both earphones, put the earphones back into the charging case, wait till their power goes off and remove them from the case.