> Connecting (Power On) > Reconnect

Reconnect

Turn on the Bluetooth function on the device to connect, followed by taking both earphones from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

connecting_XC90T_1

If reconnection cannot be established, operate the BLUETOOTH device to connect.

If connection is not established for more than 5 minutes, the power of the earphones automatically turn off.

1Check that the power of the earphones is off. Power Off

2Turn on the BLUETOOTH function of the device to connect, followed by touching and holding the L and R touch sensor area of the earphones at the same time for about 3 seconds.

PLAY_button_LR_XC90T + Button LR XC90T

Touch sensor area

  1. The indicator on the earphone lights up in red for 1 second and the power turns on.

  2. When the indicator starts to flash slowly in red, the earphones will attempt to establish connection with the last connected device.

  3. After connection is established, the L and R indicators start to flash slowly in red.

  4. blue_flash_XC90T

    The earphones reconnect with the device that was last connected and can now be used for listening to music.

If reconnection cannot be established, operate the BLUETOOTH device to connect.

If you cannot hear sounds from both earphones, it means that the L and R earphones are not connected. In this case, turn off the power of both the L and R earphones, followed by turning on their power again at the same time.

Touching and holding the touch sensor area for about 5 seconds switches the indicators to quick flashing in red. If this occurs, turn off the power of the earphone and repeat the steps from the beginning. Power Off

If connection is not established for more than 5 minutes, the power of the earphones automatically turn off.