Indicator Display on the Main Unit

TOP

Meaning of the lighting figures

Operation mode display

Displays using the different colors and solid/blinking light of the “STANDBY/ON” indicator.

Estimated timing for lamp replacement

Displays using the solid/blinking light of the “LAMP” indicator. The “STANDBY/ON” indicator, which shows the operating mode of the unit, is displayed simultaneously as described above.

Warning display

You can tell the details of a warning from the (repeated) displays of the “WARNING” and “LAMP” indicators. The “STANDBY/ON” indicator, which shows the operating mode of the unit, is displayed simultaneously as described above.

The Warning mode is activated once the message is displayed. Projection is interrupted, and the cooling fan is turned on for about 100 seconds.

The power cannot be turned on again while cooling is in progress. Check the following after cooling is complete.

Blinking Frequency	Description	Check and Countermeasure
x1	Abnormality in the power supply	Check that nothing is blocking the air inlets. Check that the external temperature is normal. Countermeasure: Leave the unit unoperated until it cools down. After that, turn on the power again.
x2	Cooling fan stopped abnormally
x3	Internal temperature is abnormally high
x4	External temperature is too high
x5	Abnormal circuit operation
x1	Abnormal circuit operation
x2
x3
x4	Abnormal operation of the lens cover	Check that nothing is blocking the lens cover. Countermeasure: Turn on the power again.
x1	Lamp does not light up and unit is unable to project	Check that the lamp unit and lamp cover are correctly installed. Countermeasure: Turn on the power again.
x2	Lamp goes out during projection
x3	When the lamp cover is removed

If the Warning mode is activated again, wait for the cooling fan to stop, followed by pulling out the power plug from the outlet.
Request for repair at your authorized dealer or a nearby service center.

(*) If the scheduled time for lamp replacement is exceeded, the indicator may light up.