> Connecting > Pairing

Pairing

1Check that the power is turned off.

Power lamp OFF XP50BT

2Press and hold power until the indicator repeatedly flashes red and blue quickly and alternately.

Release your finger once you confirmed that the indicator is repeatedly flashing red and blue quickly and alternately.

connecting XP50BT

If the indicator does not flash red and blue quickly and alternately (flashing in red for example), refer to Power Off to turn off the power, then press and hold power again.

3Turn on the Bluetooth function of the BLUETOOTH device.

connecting 2 New

4Select “JVC HA-XP50BT” from the device list.

connecting 3 XP50BT

The indicator flashes slowly in blue when a connection is completed.

blue_flash_XP50BT

During the pairing process, the BLUETOOTH device may require input of a PIN code. In such a case, enter “0000” as the PIN code for the System.

If connection (pairing) is not completed within 5 minutes after the indicator starts flashing, the System automatically turns itself off.