This function sets the Auto Patrol operation which patrols multiple positions at specified time intervals. You can set the order in which to view the determined positions.
[Auto Patrol] Page
TOPThis page can be used during access using “admin” or “operator”.
Open the side menu by clicking [Advanced Settings] in the menu, followed by clicking [Auto Patrol 0], [Auto Patrol 1], or [Auto Patrol 2].
Press the [OK] button to enable the new settings.
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made.
Settings
There are three screens in Auto Patrol.
(The screen below appears when [Auto Patrol 0] is clicked.)
Setting values with 
are default values.
No.
Switches the camera image from No. 0 to 99 in sequence.
Title
This displays the title of the position.
Position
This sets the position number to be moved in sequence.
[Set values: 0 to 99]
Memo
Specify the setting for Preset Position in [PTZ Settings] of Built-in Viewer.
Stay Time
This sets the duration of displaying the images at each position.
For positions that you do not want to display during Auto Patrol, set to “Skip”.
[ Set values: Skip, 10, 20, 30, 45, 60, 120]sec
Moving Speed
This item sets the speed of moving to the preset position.
[Set values: Low, Mid, High]