[Maintenance] Page

Restarts the camera. (The camera takes about 1 minute to restart.)

Restarts the camera and initializes the set values of the camera. (The camera takes about 1 minute to initialize or restart.)

All passwords are initialized as well. However, the time zone setting and the time of the clock built in the camera is not reset.

Current services such as JPEG/H.264 streaming are all stopped.

Updates the camera firmware and restarts the camera.

Copy the new firmware file to the computer where you use the Internet Explorer, and specify the file by clicking the [Browse...] button. Press the [Update] button to start firmware updating. Current services such as JPEG/H.264 streaming are all stopped. The firmware updating may take several minutes.

When the firmware is successfully updated, a message is displayed in the Internet Explorer.

If an error message appears, check the file of the selected firmware, and execute the update again.

Displays the camera’s firmware version.

Downloads the Language File.
Click [Download] button to download the “language.ini” file to computer.

Uploads the Language File.
Click [Browse...] button to display the file selection screen. Please select the “language.ini” file which you edited.
Click [Upload] button to upload the selected “language.ini” file to camera.

You can set whether to automatically clean the power and signal transmission components.
Setting to “ON” executes cleaning at the preset time specified in [Auto Cleaning Time].

Select “ON” or “OFF”, and click [Apply].

[Set values: ON, OFF]

You can set the time to start auto cleaning.

To change the setting, enter the time and click the [Apply] button.

[Set values: 0-23 h, 0-59 m, 00 h 00 m]