Maintenance after Use

After using underwater or in dusty places, rinse the camera with water immediately and dry it completely.

Ensure that the terminal cover is closed.

Rinse with clean water.

Soak the camera in a container filled with enough water to immerse the camera completely, and rinse it gently.

C4B5 Underwater2

After using the camera under the sea or on the beach, immerse the camera in fresh water for about 10 minutes to remove salt particles, replace the water and rinse the camera.

Open and close the LCD screen, and operate the buttons or zoom operations to get rid of sands or dusts in the gap.

Do not rinse the camera under running tap water or strong pressure water.

Dry the camera.

Wipe the camera completely with a soft dry cloth and allow it to dry in a well-ventilated and shady location.

Place the camera with the lens facing downward while the LCD monitor is closed, and leave it for approximately 10 minutes. (By doing so, microphone and LDC part are dried out easily.) Place the camera in a up right position on a dry cloth afterward Close the terminal cover after the camera is dried out completely.

Wipe off any foreign materials or water droplets inside the cover.

If you leave the camera immersed in salt water or allow water droplets from the salt water to remain on the camera, this may cause corrosion, discoloration or deterioration of waterproof performance.

If you wipe or dry the camera with sand particles adhered, this may cause scratches on the camera.

Do not wash with chemicals, soap, neutral detergents, or alcohol.

Do not dry the camera with a hair dryer or other heat sources. This could impair its waterproof performance.