[Alarm Environment] Page

TOP

This page sets up the alarm environment.

This page can be used during access using“admin” or “operator”.

Click [Advanced Settings]in the side menu, and click [Alarm Environment].

Press the [OK]button to enable the new settings.

If the [OK]button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel]button to restore the invalid entry to the value before the change was made. If you press the [Cancel]button, other changed items will also be restored to the values before the change was made.

Settings

Setting values with circle_B are default values.

Manual Output

Manually operate alarm output.

The current output status is displayed on the right side. When [Duration]is set to“0”, pressing the [Make] button sets the alarm to make output, and pressing the [Break] button sets the alarm to break output.
When [Duration] is set to other than “0”, pressing the [Make] button sets the alarm to make output only for the output duration time, and then changes it to break output.
When [Duration] is set to other than “0”, pressing the [Break] button sets the alarm to break output only for the output duration time, and then changes it to make output.

[Set values: Make, Break]

[Alarm Environment] Page

Settings

Alarm Output

Duration

Manual Output