Others

This camera will perform the initial operation of pan/tilt/zoom upon powering on. It takes about 90 seconds before the initial operation starts. This is not a malfunction.

Do not subject the lens to strong light source such as sun rays. This may cause the equipment to malfunction.

This camera comes with a built-in AGC circuit. The sensitivity increases automatically at a dark place and the screen may appear noisy. This is not a malfunction.

While AGC is activated, if a transceiver which causes strong electromagnetic wave is used near the camera, the picture may suffer from beat. Please use the camera more than three meters away from such transceivers.

When this camera is used in the White Balance“ATW-Narrow” or “ATW-Wide” (automatic adjustment) mode, the color tone may differ slightly from the actual color due to the principle of the automatic color temperature tracking white balance circuit. This is not a malfunction.

If a high brightness object (such as a lamp) is shot, the image on the screen may have white vertical tailings. This phenomenon (smear) is characteristic of solid-state image sensors and is not a malfunction.

Do not touch the dome cover with your hands. Dirty covers will cause image deterioration.

The dome cover may fog up due to the drastic change of temperature when humidity is high.

Noises from an external source may cause the camera to malfunction even when the alarm signal cable used is within 50 m. In this case, move the cable away from the noise source.

Depending on the stop position and rotation speed of the horizontal/vertical rotation platform, the running sound of the rotation platform’s motor may be heard, but this is not a malfunction.

The electronic shutter of this product is set to“1/30” by default. For regions with a commercial power supply frequency of 50 Hz, switch to “Flickerless” during use under fluorescent lights (excluding inverter lighting equipment) to prevent flickers.

The dark areas on the screen may appear grainy or white spots may increase. When switching between color and black-and-white images, the brighter area on the screen is emphasized, which may reduce the visibility. However, this is not a malfunction.

If the power supply voltage is momentarily cut off or reduced due to lightning or turning on of the air conditioner’s power, the image may be disrupted or noise interference may occur.

As the dome cover is of a semiglobular shape, image distortion will occur at the hemispherical edge. When the hemispherical edge of this unit is masked and horizontal level is shot in a tilt direction, the hemispherical edge will enter the field angle. This may cause the upper edge of the screen to become black and the focus unclear. In this case, you can avoid shooting the above area by using the Tilt Limit settings.

When shooting objects with a luminance difference or near a light source, ghost may occur on the screen. This is a feature of the dome cover and the built-in lens, and is not a malfunction.

In particular, manual and auto pan operation near the TELE edge (telephoto side) may cause the screen to vibrate (unsmooth rotation). This is a feature of the motor and is not a malfunction.

As long magnification lens is used in this product, the focus may be unclear due to temperature changes but this is not a malfunction.

Preset the focus under an environment with a temperature closest to that in your actual usage. If the temperature change is large and the focus becomes unclear, preset the focus again before using the product.

If you sense that the focus has become unclear due to temperature changes, use the Auto Focus function or reset the focus manually.

The time of the internal clock may be significantly out of alignment if the power of the product is turned off for a long time or when there is prolonged power failure. If this occurs, readjust the clock time.

Replace the fan every five years.