[Maintenance] Page

TOP

This page maintains the camera system.

This page can be used during access using“admin”.

Click [Advanced Settings]in the side menu, and click [Maintenance].

Settings

Restart, Initialize

Restart

Restarts the camera. (The camera takes about 1 minute to restart.)

All Settings

Restarts the camera and initializes the set values of the camera. (The camera takes about 1 minute to initialize or restart.)

All passwords are initialized as well. However, the time zone setting and the time of the clock built in the camera is not reset.

Current services such as JPEG/H.264 streaming are all stopped.

Firmware

Update

Updates the camera firmware and restarts the camera.

Copy the new firmware file to the computer where you use the Internet Explorer, and open the file by pressing the[Browse...] button. Press the [Execute] button to start firmware updating. Current services such as JPEG/H.264 streaming are all stopped. The firmware updating may take several minutes.

When the firmware is successfully updated, the message is displayed in the Internet Explorer.

Memo

Executing update does not reset the camera settings.

Note

Do not shut down the system and computer power supplies when the firmware is being updated and when the camera is restarting immediately after firmware updating. If the power is shut down, it may cause a malfunction of camera.

Before starting firmware updating, terminate any access to the camera (by the viewer or others), except for the access from the Maintenance Page. If an access to the camera from anything other than the Maintenance Page is valid, and if you start to update the firmware, the access from this Maintenance Page may be disconnected. If it occurs, terminate the access from anything other than the Maintenance Page. Then, access to this Maintenance Page again and restart firmware updating.

Version

Displays the camera’s firmware version.

Auto Cleaning

You can set whether to automatically clean the power and signal transmission components.
Setting to “ON” executes cleaning at the preset time specified in [Auto Cleaning Time].

Select “ON” or “OFF”, and click [Apply].

[Set values: ON, OFF]

Note

When the camera has stopped at the pan position for more than 7 days, it will pan at the specified time and perform cleaning automatically. Cleaning takes about 1 second to complete.