Set the camera to the recording mode.
-
- Using Wi-Fi by Creating a QR Code
-
DIRECT MONITORING
DIRECT MONITORING
Setting (Once setting is done, start from the “Regular Operation” below)
1Creating a QR Code
Enter values in the required items for direct monitoring.
Password: set a password to connect this camera to the device by direct monitoring. (8 to 63 characters (64 characters in case of hexadecimal))
Enforced Group Owner: setting used to enable a connection with a device that does not support Wi-Fi Direct. Normally set to “ON”.
HTTP Port: Normally set to “80”.
2Display the screen for reading the QR code.
Tap “MENU”.
(Operation on this camera)
The top menu appears.
Tap the “Wi-Fi” ( 
) icon.
(Operation on this camera)
_UJDCILympypskr.png)
Tap “Wi-Fi SETTING”.
(Operation on this camera)
Tap “SET FROM QR CODE”.
Tap “EXECUTE”.
3Read a QR code.
Read a QR code.
(Operation on this camera)
Tap “YES”.
Tap “OK”.
Tap “NEXT” to return to the screen to read the QR code.
Set contents are saved.
Regular Operation
4Connecting the Smartphone to the Camera Wirelessly
Connection by entering the Wi-Fi password
Tap “MENU”.
(Operation on this camera)
The top menu appears.
Tap the “Wi-Fi” ( ) icon.
(Operation on this camera)
Tap the “DIRECT CONNECTION” ( 
) icon in the “Wi-Fi” menu.
(Operation on this camera)
When “50p” is selected for “SYSTEM SELECT”, the following display appears and recording mode is switched to the 50i mode.
This display disappears automatically after approximately 3 seconds, but disappears immediately if the screen is tapped.
Check the SSID and the PASS being displayed on the screen of the camera.
Select the SSID in step 4 from the Wi-Fi network selection screen of your smartphone, and enter the PASS on the password screen.
(Operation on the smartphone)
For details on connecting your smartphone to a Wi-Fi network, please refer to the instruction manual of the device in use.
A connection is established and appears on the camera’s screen.
Connection by Wi-Fi Protected Setup (WPS)
Tap “MENU”.
(Operation on this camera)
Set the camera to the recording mode.
The top menu appears.
Tap the “Wi-Fi” ( ) icon.
(Operation on this camera)
Tap the “DIRECT CONNECTION” ( ) icon in the “Wi-Fi” menu.
(Operation on this camera)
When “50p” is selected for “SYSTEM SELECT”, the following display appears and recording mode is switched to the 50i mode.
This display disappears automatically after approximately 3 seconds, but disappears immediately if the screen is tapped.
Tap “WPS”.
(Operation on this camera)
Activate WPS on the smartphone within 2 minutes.
(Operation on the smartphone)
To activate WPS, refer to the instruction manual of the device in use.
A connection is established and appears on the camera’s screen.
5Monitoring Images from Smartphone
Smartphone (Android / iPhone)
Memo
Prior to use this function, a smartphone application needs to be installed on the smartphone.
Start “Everio sync. 3” on the smartphone after setting DIRECT MONITORING.
Tap “DIRECT MONITORING”.
The recording screen is displayed.
