> Connecting (Power On) > Using only one earphone

Using only one earphone

After the BLUETOOTH function of the device to connect is turned on, one earphone can now be used on its own.

Take out the earphone that you wish to use from the charging case. The power of the earphones turns on automatically, and they are automatically reconnected with the last connected device.

Be careful not to touch the touch sensor area when taking them out.

Case_button_FW1000T_L_U + Case button FW1000T L_U

Touch sensor area

For remote control operation, only the earphone that is in use can be used.

To use the earphone taken out of the charging case, wear it in your ear and touch the touch sensor area of the earphone for about 3 seconds to turn on the power.

If pairing has not been performed, do so before using. Pairing (Registering a device)

To use both earphones, put the earphones back into the charging case, wait till their power goes off and remove them from the case.

When using only one earphone, toggling of the noise canceling function and the ambient sound function (Touch & Talk function) cannot be used.