Meaning of the front panel indicators
Operation mode display
Displays using the different colors and solid/blinking light of the indicator on the projector unit.
Warning display
You can tell the details of a warning from the (repeated) displays of the “WARNING” and “LIGHT” indicators. The “STANDBY/ON” indicator will light up or appear blinking according to the operation mode of the projector unit. (Please refer to “Operation mode display”.)
The Warning mode is activated once the message is displayed. Projection is interrupted and the cooling fan starts running.
The power cannot be turned on again while cooling is in progress. Check the following after cooling is complete.
If the Warning mode is activated again, wait for the cooling fan to stop, followed by pulling out the power plug from the outlet. Then pull out the power plug from the power outlet. Call your authorized dealer for repair.
|
Indicator Status |
Blinking Frequency |
Description |
Check and Countermeasure |
||
|---|---|---|---|---|---|
|
WARNING |
LIGHT |
STANDBY/ON |
|||
 (Red) |
 |
 Mode Display |
x2 |
Cooling fan stopped abnormally |
Check that nothing is blocking the air inlets. Check that the external temperature is normal. Countermeasure: Leave the unit unoperated until it cools down. After that, turn on the power again. |
|
x3 |
Internal temperature is abnormally high |
||||
|
x4 |
External temperature is too high |
||||
|
(Red) |
 (Orange) |
Mode Display |
x1 |
DD board occurs error |
|
|
x2 |
Fan motor board occurs error |
||||
|
x3 |
CPU board occurs error |
||||
|
x4 |
Power board occurs error |
||||
 (Red) |
(Orange) |
Mode Display |
x1 |
Abnormality in the light source |
Request for repair at your authorized dealer or a nearby service center. |
|
x2 |
|||||
|
x3 |
|||||
|
x4 |
When the safety switch is activated |
||||
 |
|
 (Green) |
x3 |
The remote control code differs between this unit and the remote control |
Set the remote control code for this unit and the remote control correctly. |