This page sets the protocol.
[Protocol] Page
TOPThis page can be used during access using “admin”.
Memo
Press the
If the
When you connect via Internet Explorer after changing protocol settings, enter the address using the new server port and port number in the address bar.
Settings
Setting values with 
are default values.
HTTP/HTTPS
For selecting the protocol to use.
[Set values: HTTP, HTTPS]
HTTP Server Port
You can change the port number for the built-in HTTP server of the camera.
[Set values: 11 to 80 to 65524]
Memo
To access the camera from Internet Explorer, input the following into the Internet Explorer address bar with the camera in the factory default state.
http://192.168.0.2
When the port number is changed to 8080, input the new port number after the IP address as follows.
http://192.168.0.2:8080
Input “:” + port number
Upon changing the HTTP server port, the port number for requesting video stream distribution will also be changed.
Set
HTTPS Server Port
You can change the port number for the built-in HTTPS server of the camera.
[Set values: 11 to 443 to 65524]
Memo
To access the camera from Internet Explorer, input the following into the Internet Explorer address bar with the camera in the factory default state.
https://192.168.0.2
When the port number is changed to 8080, input the new port number after the IP address as follows.
https://192.168.0.2:8080
Input “:” + port number
Upon changing the HTTPS server port, the port number for requesting video stream distribution will also be changed.
SNMP
For setting SNMP.
[Set values: ON, OFF]
AMX Device Discovery Protocol
You can change the AMX device detection protocol. Set to “ON” when you are using the camera on AMX’s system.
[Set values: ON, OFF]
ONVIF
You can change the standard surveillance protocols.
[Set values: ON, OFF]
Priority
Selects whether to give priority to the client number for JPEG image streaming or the frame rate.
Client Number:
Gives priority to the streaming client number. Lowers the JPEG frame rate as delivery requests increase, allowing delivery to a maximum of 20 clients.
Framerate:
Assigns priority to the frame rate. Set this to maintain the frame rate for JPEG images requested by clients. Delivery requests that exceed the maximum number will be denied.
[Set values: Client Number, Framerate]