[Time] Page

TOP

This page sets the current clock time.

This page can be used during access using “admin”.

Press the [OK] button to enable the new settings.

If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.

Memo

The time of the internal clock may be significantly out of alignment if the power of the product is turned off for a long time or when there is prolonged power failure. If this occurs, readjust the [Time] setting.

Settings

Setting values with circle_B are default values.

SNTP

Sets the SNTP client function.

ON:
Gets the time by periodically accessing the specified NTP server.

OFF:
Does not access the NTP server.

[Set values: OFF, ON]

Memo

The time is recorded in the JPEG header and H.264 header distributed by the camera. The time recorded in the JPEG header and H.264 header may be discontinuous immediately before and after acquiring the time from the NTP server.

SNTP Server

Sets an IP address of NTP server.

[Factory default: 0.0.0.0]

Interval

Sets a unit and values of measurement for the time interval at which to access the NTP server.

[Set values: Min(1-60), Hour(1-24), Day(1-31)]

Time

Displays the clock time of camera.

You can correct the time by entering a value (without seconds).

Memo

The time is recorded in the JPEG header and H.264 header distributed by the camera. Discontinuity may occur in the time of the JPEG header and H.264 header immediately before and after changing the time.

Change the [Time] if it does not coincide with the [Time Zone] of the region you are residing.

Time Zone

Sets a time zone.

[Set values: (GMT-12:00) to (GMT)UTC to (GMT+12:45)]

Memo

After changing the [Time Zone], check to ensure that the [Time] is correct. If it is incorrect, readjust the [Time] accordingly.

Note

When the [Time Zone] settings are changed to a value different from the factory default, they cannot be restored to the factory settings even by initializing using [All Settings] on the [Maintenance] page.

[Maintenance] Page

[Time] Page

Settings

SNTP

SNTP Server

Interval

Time

Time Zone

PC Time to Camera