[Network] Page

TOP

This page sets the network settings.

This page can be used during access using “admin”.

Click [Network] in the side menu.

Press the [OK] button to enable the new settings.

If you change the settings, the camera will restart. The camera takes about 90 seconds to restart.

If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.

Memo

If you change the settings other than host name and DNS server on the [Network] page, all of the currently operating services are terminated. For example, if you change a setting on the [Network] page during JPEG/H.264 file distribution, the file distributions are stopped and the TCP connection is disconnected.

Settings

Setting values with circle_B are default values.

IP Setting

Sets the DHCP client function.

To enable the DHCP, connect the camera to the network environment where the DHCP server is running.

If the DHCP server does not exist when DHCP is set to “Enable”, camera will start running with the 192.168.0.2 IP address and 255.255.255.0 subnet mask in about 2 minutes after startup. For details on entering the IP address, refer to the following.

IP Address Setting Procedure

[Set values: DHCP Disable, DHCP Enable]

IP Address

Sets the IP address of camera.

[Factory default: 192.168.0.2]

Subnet Mask

Sets the subnet mask of camera.

[Factory default: 255.255.255.0]

Default Gateway

Sets the default gateway of camera.

Enter 0.0.0.0 if you do not want to set a default gateway.

[Factory default: 0.0.0.0]

Host Name

Sets a host name of camera.

It can consist of alphanumeric characters, hyphen (-), and period (.). Underscore (_) character is not allowed to use.

DNS Server

Sets an address of DNS server.

[Factory default: 0.0.0.0]

MAC Address

The MAC address of camera is shown as a hexadecimal number.

Negotiation

Sets the network negotiation.

If you have selected a value other than “Auto”, do not set the connected network device to “Auto”. Be sure to set it to the same value as the camera.

[Set values: Auto, 100M Full, 100M Half, 10M Full, 10M Half]

Note

The camera and another connecting device on the network may connect automatically when other than “Auto” is selected for the camera and “Auto” is set for the other connecting device.

When connection is established with “100M Half” or “10M Half”, restriction on the communication line applies, and sending and receiving cannot be executed simultaneously. If video streams are distributed from the camera in this state, sending of instructions such as PTZ operation to the camera may fail.

[Network] Page

Settings

IP Setting

IP Setting

IP Address

Subnet Mask

Default Gateway

Host Name

DNS Server

MAC Address

Other

Negotiation

MTU