Sets a display item on the viewer screen.
For the Built-in Viewer, characters are displayed as overlay on the video image.
This page can be used during access using “admin” or “operator”.
When the Control Menu is open, click
Click
When you click the
When “ON” is selected, the
You can set the
[Set values: ON, OFF]
When “ON” is selected, the position title is displayed in the lower left of the screen.
[Set values: ON, OFF]
Selecting “ON” displays a red frame around the area in the image where motion or tampering is detected.
[Set values: ON, OFF]
Set to “ON” to display the time.
Displays the time information stored in the JPEG data or stream data at the bottom right of the screen.
Stream data: Stream data encoded with H.264 Baseline or H.264 High.
[Set values: ON, OFF]
You can display the time at the bottom right corner of the screen by setting Time under
If the level of performance is not sufficient for decoding and displaying the received video, the time display on the Built-in Viewer screen may appear in a different color. This is part of the design specifications, and is not a malfunction.
If the time is not displayed in white, try lowering the parameters such as the frame size and frame rate of the encoder corresponding to the video displayed on the Built-in Viewer to reduce the load on the computer.
For details on the encoder’s parameter settings, refer to the following.
Selects a time display format. YYYY, MM and DD denote the year, month and days. HH, MM and SS are hours, minutes and seconds. mm is 1/100 seconds.
[Set values: YYYY/MM/DD HH:MM:SS.mm, YYYY/MM/DD HH:MM:SS, DD/MM/YYYY HH:MM:SS, MM/DD/YYYY HH:MM:SS, MM/DD HH:MM:SS, HH:MM:SS, HH:MM]
Getting Started
Camera Setting Requirements
Mounting the Camera
IP Address Settings
Setting Using Internet Explorer
Operation
Others