[Basic Setting1] Page

TOP

This page is for performing basic setting related to the network.

This page can be used during access using “admin”.

Click [Basic Setting1] in the side menu.

Press the [OK] button to enable the new settings.

If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made.

Memo

If you enter the following URL directly into the address bar of Internet Explorer, you can open the [Basic Setting1] page without going through the Built-in Viewer.
http://192.168.0.2/cgi-bin/display.cgi?basicmenu1.html
(When the IP address of the camera is 192.168.0.2)

Settings

Setting values with circle_B are default values.

Network

IP Setting

Sets the DHCP client function.
To enable the DHCP, connect the camera to the network environment where the DHCP server is running.
If you have set the IP Setting to “DHCP Enable” but the DHCP server does not exist, the camera will start with the IP address “192.168.0.2” and subnet mask “255.255.255.0” approximately 2 minutes after startup.

[Set values: DHCP Disable, DHCP Enable]

IP Address

Sets the IP address of camera.

[Factory default: 192.168.0.2]

Subnet Mask

Sets the subnet mask of camera.

[Factory default: 255.255.255.0]

Default Gateway

Sets the default gateway of camera.
Enter 0.0.0.0 if you do not want to set a default gateway.

[Factory default: 0.0.0.0]

Time

Time (read only)

Displays the clock time of the camera. The time transmitted by the camera is recorded in the JPEG header.

Memo

This item does not allow you to alter the camera’s clock time. For details about the Time settings, refer to the [Time] page.

[Time] Page

Time Zone

For setting the time zone.

[Set values: (GMT-12:00) to (GMT) UTC to (GMT+12:45)]

Note

When the [Time Zone] settings are changed to a value different from the factory default, they cannot be restored to the factory settings even by initializing using [All Settings] on the [Maintenance] page.

[Maintenance] Page

PC Time to Camera

Click the [Set] button to set the time of the computer on the camera.

Memo

The time zone of the computer cannot be reflected. Only the time will be set.