This page is for setting manual multicast transmission.
[Multicast] Page
TOPThis page can be used during access using “admin” or “operator”.
Press the
If the
Memo
When the power of the camera is turned off accidentally during multicast transmission, multicast transmission will restart automatically after the camera is rebooted.
Settings
Setting values with 
are default values.
Encoder No.1 to No.3
For setting manual distribution by Encoder No.1 to No.3.
Memo
Only the setting options for the encoder in operation will be displayed.
Encode
Displays the
[Displayed values: JPEG, H.264 Baseline, H.264 High]
Framesize
Displays the
Framerate
Displays the
The frame rate can be changed when Encode is set to “JPEG”.
[Set values: 30 fps, 15 fps, 10 fps, 7.5 fps, 5 fps, 3 fps, 2 fps, 1 fps, 1/2 fps, 1/3 fps, 1/5 fps, 1/10 fps, 1/30 fps]
Memo
You can specify a frame rate that does not exceed the upper limit specified in the
Destination Address
For specifying the destination address for distribution by the preset encoder.
Specify the multicast address. When other devices that make use of multicast transmission exist, ensure that each of them is set to a different multicast address.
[(Factory default) Encoder No.1: 225.0.1.1, Encoder No.2: 225.0.2.1, Encoder No.3: 225.0.4.1]
Destination Port
For specifying the destination port number for distribution by the preset encoder.
Specify an even number for RTP compliance. When other devices that make use of multicast transmission exist, it is recommended that each of them be set to a different port number.
Multiple multicast streams cannot be received on a single computer when there are duplicate port numbers.
[(Factory default) Encoder No.1: 49152, Encoder No.2: 59152, Encoder No.3: 29152]
Start
Saves the encoder settings and starts manual distribution.
It is displayed as a
The frame rate, destination address, and destination port cannot be changed while distribution is in progress.