[Motion Detection] Page

TOP

This page is for setting motion detection.

This page can be used during access using “admin” or “operator”.

The area valid for motion detection is displayed in blue.

When motion is detected, the area around the screen is highlighted in red.

Motion detection is valid only when the camera is at the home position.

Click [Advanced Settings] in the side menu, and click [Motion Detection].

Press the [OK] button to enable the new settings.

If the distribution capability of the camera is exceeded when images are acquired from the camera by the Built-in Viewer or other clients, images may not appear on the [Motion Detection] page. Stop the Built-in Viewer or other clients before using the [Motion Detection] page.

Exiting Built-in Viewer

If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.

Memo

The area display position serves as a reference. Make sure to perform operation check.

The screen is divided into 96 blocks (12 horizontal batsu 8 vertical). Set the angle of view such that the size of the object for which motion is to be detected is at least the size of two blocks.

You cannot set an area in a zoomed image.

Note

Flickers of fluorescent lamps may falsely trigger motion detection.

Changes in brightness due to the light source may be detected as motion.

The motion detection feature is not intended to prevent theft or fire. This feature may not function properly depending on the conditions of the object and settings.
Our company shall not be liable for any accident or damage that occurs.

Detection may not work depending on the installation conditions and subject.

When [Tampering Detection] is set to “ON”, the motion detection feature cannot be used.

Settings

Setting values with circle_B are default values.

Motion Detection Area

When the motion detection area is displayed, the screen is divided into 12 horizontal 8 vertical blocks, allowing you to specify motion detection settings for each block.
Click on the block to detect motion. The block appears in blue, indicating that it is now enabled for motion detection. Right-clicking on a blue block clears the blue display and excludes it from motion detection. By moving the mouse with the left or right button pressed down, you can select multiple blocks at the same time.
After setting all the blocks, press the [OK] button to enable the motion detection settings for each of the blocks.

Motion Detection

For setting motion detection to On/Off.

[Set values: ON, OFF]

Level

For setting the sensitivity of motion detection. Increasing the number raises the detection sensitivity level, and hence it is more sensitive.

[Set values: 0 to 4 to 10]

All Mask

Masks all blocks, and cancels the motion detection settings. (The blue display for all the blocks is cleared.)

Clear Mask

Clears the masks for all blocks, and enables the motion detection settings. (All blocks are displayed in blue.)