In normal recording, when the recording stops, the image and accompanying data from the start till the end of the recording are recorded as one “clip” on the SD card.
Interval Rec
TOPIn this mode, recording and pause are performed repeatedly at the specified time interval. Only the specified number of frames is recorded.
The recording can be written to the media as a single clip until it is stopped.
Memo
Audio will not be recorded.
Until a specified amount of recordings is accumulated, the file will not be written to the media.
After the specified number of frames is recorded and written to the media, recording will be performed until the same number is accumulated again.
If the specified amount is not reached when recording is stopped, normal recording is performed and frames are added to the ending of the clip until the amount is reached. (Padding)
Set [Rec Mode] to “Interval Rec”.
Set [Main Menu] 
[System] [Record Set] [Rec Mode] to “Interval Rec”.
The display changes (“STBY” “STBY 
”).
Set the number of frames to record in [Rec Frames].
Set using [Main Menu] [System] [Record Set] [Rec Mode] [Rec Frames].
Set the time interval to start recording in [Interval Rec].
Set using [Main Menu] [System] [Record Set] [Rec Mode] [Rec Interval].
Start recording.
Press the [REC] button to record only the number of frames specified in [Rec Frames] and pause.
After the specified time in [Rec Interval] has passed, recording starts again to record only the number of frames specified in [Rec Frames] and pause.
Interval Rec continues until the recording is stopped.
The display changes (“STBY ” “ 
REC ” “STBY ” (red text) “ REC ” “STBY ” (red text)).
The card slot status indicator blinks in green.
Press and hold the [REC] button.
The card slot status indicator lights up in green.
The display becomes “STBY ”.
Caution
Do not remove the SD card during recording ( REC , red text) or recording pause (STBY , yellow text).
To remove the SD card during Interval Rec, press the [CANCEL] button, check that “STBY ” (white text) is displayed and the card slot status indicator lights up in green before you remove the card.
When [Main Menu] [TC/UB] [TC Generator] is set to “Free Run” or “Free Run(Ext)”, the time code will be recorded in “Rec Run”.
Audio cannot be recorded. A 
mark appears in the audio level meter display.