Global
Mobile User Guide

Using a Battery Pack

TOP

Charging the Battery

Charge the battery immediately after purchase or when the battery power is running low.

The battery is not charged when purchased.

600_Batt
Hold down the lock button (blue) at the center of the [POWER ON/OFF(CHG)] switch to set to “OFF(CHG)”.
Attach the supplied battery.

Slide it in until you hear a click.

Connect the supplied AC adapter to the [DC] terminal.

Open the cover of the [DC] terminal and connect as shown in the diagram.

Connect the AC adapter to a power outlet.

The [POWER/CHG] lamp blinks during charging and will go out after charging is complete.

Remove the AC adapter after charging is complete.

Memo

Blinking of the [POWER/CHG] lamp during charging indicates the charge level.

[POWER/CHG] Lamp

Charge Level

Orange blinking (4 times per second)

Less than 25%

Orange blinking (3 times per second)

Less than 50%

Orange blinking (2 times per second)

Less than 75%

Orange blinking (1 time per second)

Less than 100%

Light goes out

Fully charged

Removing the Battery

600_BattOut
Hold down the lock button (blue) at the center of the [POWER ON/OFF(CHG)] switch to set to “OFF(CHG)”.
While pressing and holding the [BATT. RELEASE] button, push up and remove the battery in the direction of the arrow.
Caution

Do not remove the battery when the [POWER ON/OFF(CHG)] switch is “ON”.

Do not insert or remove the DC cable when the battery is in use.

Leaving the camera recorder unused with the battery inside will deplete the battery power even if you set the [POWER ON/OFF(CHG)] switch to “OFF(CHG)”. Remove the battery if you are not using the camera recorder.

Estimated Charging and Continuous Operating Times

STOP button Charging Time (supplied SSL-JVC50 battery pack)

Approx. 4 h

Memo

Use up the charge completely before you charge the battery. If the battery is not fully discharged before charging, the battery capacity may drop after repeated cycles.

If the battery capacity drops due to repetitive shallow charging and discharging, it may be recovered by using up the charge completely and then fully charging the battery again.

If you charge the battery immediately after using while the battery is still warm, it may not be fully charged.

It is recommended that you charge the battery in an environment between 10 °C and 35 °C (50 °F and 95 °F). The battery may not be fully charged or the charging time may be prolonged if charged under low temperatures (below 10 °C/50 °F).

STOP button Continuous Operating Time (supplied SSL-JVC50 battery pack)

Approx. 1 hrs 50 mins

Memo

Actual operating times may differ depending on the age of the battery, charging condition, and operating environment.

Operating time is shortened in cold environment.

The operating time may shorten when power zoom is used, accessories are connected, or when the LCD monitor is frequently used.

For purchase of spare batteries and battery charger, consult your nearest JVC dealer.

Precautions for Batteries

Store the battery in a cool and dry place when not in use. Do not expose the battery to high temperatures (such as in a car under direct sunlight). This will cause battery leakage and shorten the battery life.

If the operating time shortens drastically even after charging, the battery may be reaching the end of its life. Replace the battery with a new one.

Global
Mobile User Guide
GY-HM650U/GY-HM650E
Mobile User Guide