This page sets the protocol.
[Protocol] Page
TOPThis page can be used during access using “admin”.
Memo
Press the [OK] button to enable the new settings.
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.
When you connect via Internet Explorer after changing protocol settings, enter the address using the new server port and port number in the address bar.
Settings
Setting values with 
are default values.
Protocol Settings
Sets the protocols.
HTTP/HTTPS
For selecting the protocol to use.
[Set values: HTTP, HTTPS]
HTTP Server Port
You can change the port number for the built-in HTTP server of the camera.
[Set values: 11 to 80 to 65524]
Memo
To access the camera from Internet Explorer, input the following into the Internet Explorer address bar with the camera in the factory default state.
http://192.168.0.2
When the port number is changed to 8080, input the new port number after the IP address as follows.
http://192.168.0.2:8080
Input “:” + port number
Upon changing the HTTP server port, the port number for requesting video stream distribution will also be changed.
Set [HTTP Port] of the Built-in Viewer to the same value.
HTTPS Server Port
You can change the port number for the built-in HTTPS server of the camera.
[Set values: 11 to 443 to 65524]
Memo
To access the camera from Internet Explorer, input the following into the Internet Explorer address bar with the camera in the factory default state.
https://192.168.0.2
When the port number is changed to 8080, input the new port number after the IP address as follows.
https://192.168.0.2:8080
Input “:” + port number
Upon changing the HTTPS server port, the port number for requesting video stream distribution will also be changed.
SNMP
For setting SNMP.
[Set values: ON, OFF]
AMX Device Discovery Protocol
You can change the AMX device detection protocol. Set to “ON” when you are using the camera on AMX’s system.
[Set values: ON, OFF]
Standard Surveillance Protocol
Sets standard surveillance protocols.
ONVIF
You can change the standard surveillance protocols.
[Set values: ON, OFF]
JPEG Streaming
Selects the JPEG image streaming priority.
Priority
Selects whether to give priority to the client number for JPEG image streaming or the frame rate.
Client Number:
Gives priority to the streaming client number. Lowers the JPEG frame rate as delivery requests increase, allowing delivery to a maximum of 20 clients.
Framerate:
Assigns priority to the frame rate. Set this to maintain the frame rate for JPEG images requested by clients. Delivery requests that exceed the maximum number will be denied.
[Set values: Client Number, Framerate]