This page sets the current clock time.
[Time] Page
TOPThis page can be used during access using “admin”.
Press the [OK] button to enable the new settings.
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.
Memo
The time of the internal clock may be significantly out of alignment if the power of the product is turned off for a long time or when there is prolonged power failure. If this occurs, readjust the [Time] setting.
Settings
Setting values with 
are default values.
SNTP
Sets the SNTP client function.
ON:
Gets the time by periodically accessing the specified NTP server.
OFF:
Does not access the NTP server.
[Set values: OFF, ON]
Memo
The time is recorded in the JPEG header and
SNTP Server
Sets an IP address of NTP server.
[Factory default: 0.0.0.0]
Interval
Sets a unit and values of measurement for the time interval at which to access the NTP server.
[Set values: Min(1-60), Hour(1-24), Day(1-31)]
Time Zone
Sets a time zone.
[Set values: (GMT-12:00) to (GMT)UTC to (GMT+12:45)]
Memo
After changing the [Time Zone], check to ensure that the [Time] is correct. If it is incorrect, readjust the [Time] accordingly.
Note
When the [Time Zone] settings are changed to a value different from the factory default, they cannot be restored to the factory settings even by initializing using [All Settings] on the [Maintenance] page.