Built-in Viewer Screen Configuration
TOPBuilt-in Viewer settings are stored in cookies.
From this Settings screen, you can set up the Built-in Viewer as the software on the computer. You cannot set up camera operations from this screen.
For the latest firmware version, please visit our website.
(The latest firmware version can be found on the Download page of V.NETWORKS.)
If you delete the cookies, the current viewer settings are deleted. The next time when you start the Built-in Viewer, the viewer will operate in the initialized state.
Setting values with 
are default values.
Protocol
Selects a protocol to be used when the viewer acquires data from the camera.
HTTP(Unicast):
Allows monitoring the camera with a single viewer. If a packet is lost, the packet data is transmitted again and recovered.
RTP(Multicast):
Allows multiple viewers to monitor the camera.
[Set values: HTTP(Unicast), RTP(Multicast)]
When playing back via multicast, start multicast transmission on the [Multicast] page.
If you select “RTP(Multicast)” and start the Built-in Viewer, you may be alarmed by the Windows Firewall.
In this case, select “Do not block” and proceed to the next step.
If you select “Block”, the multicast stream will be blocked by the Windows Firewall. The viewer cannot play back multicast data.
Encoder
Select the encoder No. for streaming.
[Set values: No.1, No.2, No.3]
When [Protocol] is set to “RTP(Multicast)”, you need to specify [Multicast IP Address] and [Multicast Port] as well.