For specifying settings related to audio transmission on the Built-in Viewer.
[Audio Monitor] Settings
TOPThis page can be used during access using “admin” or “operator”.
When the Control Menu is open, click [Viewer Setup] to switch to the Viewer Setup Menu.
Click [Audio Monitor] to open the setting screen.
When you click the [Apply] button, the current settings are made valid on the viewer and they are stored in the computer.
Note
If you select “RTP(Multicast)” and start the Built-in Viewer, a Windows Firewall warning may appear. In this case, select “Do not block” and proceed to the next step.
If you select “Block”, the multicast stream will be blocked by the Windows Firewall, and audio cannot be received by the client computer.
Audio transmission cannot be performed if an audio driver is not installed on the computer.
Receive
For specifying settings related to reception of audio distributed by the camera.
Receive
For setting whether to enable audio reception. To receive audio, select “ON”.
[Set values: ON, 
OFF]
Protocol
For selecting the streaming format for the audio to be received.
HTTP(Unicast):
If a packet is lost, the packet data is transmitted again and recovered.
RTP(Multicast):
Allows multiple client computers to monitor the audio of the camera.
[Set values: HTTP(Unicast), RTP(Multicast)]
Memo
During multicast reception, start multicast transmission on the [Multicast] page.
Speech
For specifying settings related to audio transmission from a computer to the camera.
