This page sets up the alarm environment.
[Alarm Environment] Page
TOPThis page can be used during access using “admin” or “operator”.
Click [Advanced Settings] in the side menu, and click [Alarm Environment].
Press the [OK] button to enable the new settings.
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was made. If you press the [Cancel] button, other changed items will also be restored to the values before the change was made.
Settings
Setting values with 
are default values.
Mail Settings
For setting the mail environment when [Mail] is specified as an action on the Alarm page. If [SMTP Server], [Port Number], and [Send Mail Address] are set, the alarm action is displayed as “Preset”.
SMTP Server
For setting the IP address or FQDN of the SMTP server.
What is FQDN (Fully Qualified Domain Name)?
This is a fully qualified domain name that indicates a notation method of describing the entire host or domain name on the TCP/IP network without abbreviating.
For example, if the host name is www and the domain name is jvckenwood.co.jp, this will be denoted as “www.jvckenwood.co.jp” in FQDN.
Japanese cannot be used in FQDN. If FQDN is specified, set also the DNS server on the Network page.
Port Number
Input the port number.
[Set values: 0 to 25 to 65535]
Send Mail Address
Specify the sender’s mail address.
POP before SMTP
To enable [POP before SMTP], select “Enable” and set the POP server.
[Set values: Disable, Enable]
POP Server
For setting the IP address or FQDN of the POP server.
Port Number
Input the port number.
[Set values: 0 to 110 to 65535]
User Name
Enter the user name.
Password
Enter a password.
Alarm Output
Configure settings related to alarm output from an alarm output cable or connector.
Duration
Set the output duration for [Manual Output].
[Set values: 0, 100 to 5000] msec
Manual Output
Manually operate alarm output.
The current output status is displayed on the right side. When [Duration] is set to “0”, pressing the [Make] button sets the alarm to make output, and pressing the [Break] button sets the alarm to break output.
When [Duration] is set to other than “0”, pressing the [Make] button sets the alarm to make output only for the output duration time, and then changes it to break output.
When [Duration] is set to other than “0”, pressing the [Break] button sets the alarm to break output only for the output duration time, and then changes it to make output.
[Set values: Make, Break]